NAME
pflow —
kernel interface for pflow data
export
SYNOPSIS
pseudo-device pflow
DESCRIPTION
The pflow subsystem exports
pflow accounting data from the kernel using
udp(4) packets. pflow is compatible
with netflow version 5 and IPFIX (10). The data is extracted from the
pf(4) state table.
Multiple pflow interfaces can be created
at runtime using the pflowctlN
-c command. Each interface must be configured with a
flow receiver IP address and a flow receiver port number.
Only states created by a rule marked with the
pflow keyword are exported by
pflow.
pflow will attempt to export multiple
pflow records in one UDP packet, but will not hold a
record for longer than 30 seconds.
Each packet seen on this interface has one header and a variable
number of flows. The header indicates the version of the protocol, number of
flows in the packet, a unique sequence number, system time, and an engine ID
and type. Header and flow structs are defined in
<net/pflow.h>.
The pflow source and destination addresses
are controlled by
pflowctl(8). src is the sender IP
address of the UDP packet which can be used to identify the source of the
data on the pflow collector.
dst defines the collector IP address and the port.
The dst IP address and port must be defined to
enable the export of flows.
For example, the following command sets 10.0.0.1 as the source and 10.0.0.2:1234 as destination:
# pflowctl -s pflow0 src 10.0.0.1 dst 10.0.0.2:1234
The protocol is set to IPFIX with the following command:
# pflowctl -s pflow0 proto 10
SEE ALSO
netintro(4), pf(4), udp(4), pf.conf(5), pflowctl(8), tcpdump(8)
STANDARDS
B. Claise, Specification of the IP Flow Information Export (IPFIX) Protocol for the Exchange of IP Traffic Flow Information, RFC 5101, January 2008.
HISTORY
The pflow device first appeared in
OpenBSD 4.5 and was imported into FreeBSD 15.0 .
BUGS
A state created by
pfsync(4) can have a creation or expiration time before the
machine came up. In this case, pflow pretends such
flows were created or expired when the machine came up.
The IPFIX implementation is incomplete: The required transport protocol SCTP is not supported. Transport over TCP and DTLS protected flow export is also not supported.